Bluelab Dosetronic Peridoser Kit Manual de usuario descargar pdf (Pagina 14)

10

Version P1.3 : 151012

Bluelab Dosetronic Peridoser Kit

Bluelab Corporation Limited

Steps

1. Fix sample pot in position

Select a position on the wall that is near

the nutrient tank pump and where all

probe cables from the Dosetronic can

reach.

2. Fit Inlet Piping

Fit a “T” junction to pipes feeding the crop

and connect supplied ﬂ ushing ball valve.

3. Fit Outlet Piping

Connect piping to the outlet of the sample

pot and ﬁ x into a position where it can ﬂ ow

back into the nutrient tank.

4. Flush out plastic (swarf) and residue

Open sample pot inlet valve, allow sample

pot to ﬁ ll and then close the valve and

allow it to drain as much as possible.

5. Adjust inlet valve

Remove lid of sample pot. Adjust ﬂ ushing

ball valve until the water inside the sample

pot can ﬂ ow through the outlet pipe back

to the tank.

2.6 Wall Mount Sample Pot

Conductivity

pH

Temperature

Pipes feeding crop

To crop nutrient tank

Corner

mounting screws

Flushing Ball Valve

If the Dosetronic is being installed

into a system that is already

operating, it is an option that you

could use a submersible aquarium

pump to pump water from the

nutrient tank to the sample pot.

2

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 42 43

Comentarios a estos manuales

Sin comentarios