Bluelab Dosetronic Peridoser Kit Manual de usuario descargar pdf (Pagina 12)

Version P1.3 : 151012

Bluelab Dosetronic Peridoser Kit

Bluelab Corporation Limited

2.3 Stock Solution Location

The stock solution tanks need to be within close proximity

to your main nutrient mixing tank. This allows the

peridoser to give a consistent dose.

Align stock tanks near nutrient mixing tank.

2.4 Dosing System Set-up

The Peridoser doses an even amount of nutrient to your

tank at deﬁ ned intervals. These intervals are set in the

off times and on times found in the mode menu. The

instructions for this are on page 23 and 24.

1. Attach supplied braided hose onto the left hand side

of Peridoser nozzles and feed hose into allocated stock

tanks. Use acid resistant hose for pH solutions.

Note: To prevent ﬂ oating, ensure hose is secured to the

bottom of the tanks.

2. Attach tubing onto the right hand side of each

Peridoser nozzle. Set them up so they drop into the

nutrient mixing tank.

NOTE: Do not plug Peridoser into power until you have

programmed the Dosetronic Controller.

The nutrient and pH stock solutions must enter the

nutrient tank in a location where there is good mixing.

To prevent acid damage

on your acid piping and

ﬁ ttings, dilute your acid

solution to 10% or less.

Peridoser

Nutrient

pHNutrient

To ensure even dosing, all hoses need to be

the same length.

The stock solutions must drop into nutrient

tank, this stops a syphon action from

occurring. To avoid precipitation, A and B

nutrient must not mix until after they enter the

tank.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 42 43

Sin comentarios

Bluelab Dosetronic Peridoser Kit Manual de usuario Pagina 12