Bluelab Guardian Monitor Connect Manual Manual de usuario descargar pdf (Pagina 6)

English

3.0 Mounting the Bluelab Guardian Monitor Connect -

if wall mounting

Select a suitable location that is less than 2 meters from

your reservoir, and less than 1.5 meters from an electrical

mains outlet. NOTE: Avoid placing the Guardian Monitor

Connect where it can be damaged by direct sunlight, water

or nutrient salts.

Option 1

a) Install two fasteners (top and bottom) to the wall

172mm / 6.¾” apart.

b) Slide the Guardian Monitor Connect onto the fasteners

using the keyholes.

Option 2

a) Fix the four fasteners through each mounting hole in

each corner of the case.

Option 1

Mounting keyholes top and bottom

Option 2

Mounting holes top and bottom

3.1 Mounting the Bluelab Guardian Monitor -

if mounting on a support or bar

Select a suitable location that is less than 2 meters from

your reservoir, and less than 1.5 meters from an electrical

mains outlet. NOTE: Avoid placing the Guardian Monitor

Connect where it can be damaged by direct sunlight, water

or nutrient salts.

Fix each of the cable ties provided through the small

mounting holes in the top of the case and wrap around

the support or bar and secure.

Cable ties ﬁ xed through small

mounting holes around a

support or bar.

4.0 Install correct plug adaptor

Select the appropriate mains plug adaptor for your country.

Connect the plug adaptor to the power supply.

5.0 Connect power adaptor and Bluelab pH Probe

Connect the power adaptor into the base of the

Guardian Monitor Connect where ‘Power Input’ is

labelled. Plug the adaptor into mains power supply.

Connect the pH probe to the Guardian Monitor

Connect by lining up the lugs of the BNC ﬁ ttings.

Fasten securely by pushing the pH probe

connector on and twisting one quarter turn.

Inserting Twisting Attached

Please follow these steps before mounting your

Guardian Monitor Connect

A Note the 4 character KEY CODE on the rear of your Guardian Monitor Connect.

B Follow the getting started instructions supplied with the Bluelab Connect Stick to install the

Bluelab Connect Stick, Bluelab Connect Software and add your Guardian Monitor Connect

to your computer.

C Follow steps 3.0 to 12.0 to mount and operate your Guardian Monitor Connect.

key code: abcd

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Comentarios a estos manuales

Sin comentarios

Bluelab Guardian Monitor Connect Manual Manual de usuario Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Bluelab Guardian Monitor Connect Manual